Build a crank mechanism with the Hummingbird Robotics Kit! A crank transfers the servo’s rotation motion into a swinging pivot motion, like a door.
Popular uses of the crank mechanism include moving mouths and swinging doors. What will you create?
Build Time: 30-60 min (depending on skill level and design choice)
Hummingbird Robotics Kit Hardware*
- Hummingbird Controller (Bit Controller pictured. The Duo controller will also work)
- Battery Pack or AC Plug
- Position Servo (Your servo may look different)
- Circular Servo Horn (Black for Hummingbird Bit and white for Duo)
*All of these parts are included in any Hummingbird Robotics Kit
Suggested Craft Supplies
- Hot Glue Gun
- Scrap Cardboard
- Cardboard Box with Flaps (For beginners, we have found the 6x6x6 box works best)
This page contains affiliate links. If you use these links to make a purchase we may earn a commission at no extra cost to you.
Push the servo horn onto the servo shaft. This servo will rotate 180 degrees. If you imagine the servo as a clock, with the wire side indicating the top of the clock, align the servo horn so that the arm can swing freely between 6 o’clock and 12 o’clock.
If you are using the HS-311 servo from the Hummingbird Duo kit, your servo will need to swing in the opposite direction.
Feed the hook end of the L- shaped paperclip through the hole at the end of the cardboard arm. Make sure the wired side of the servo is pointed into the box. Use a generous amount of glue to secure the servo to the floor of the box.
If you are using the HS-311 servo from the Hummingbird Duo kit, your servo will need to be pointed in the opposite direction, with the wired pointed out of the box. In addition, you will need to place a couple of pieces of cardboard under the servo to raise it so that the servo horn does not touch the bottom of the box.
Need help getting started? Select your desired programming language and device from this page.